Protector FR.
Fender Splash Shield.

• Located between the fender and the tire
• Helps shield your vehicle from small rocks and other road debris
• Replace when cracked or broken

The fender on your INFINITI is designed to help protect the wheels and undercarriage components from incoming road debris, protect pedestrians and other vehicles from any rocks that might deflect from your tires, and minimize damage to your vehicle in the event of a collision or "fender bender."

In many INFINITI models, the fender is made up of a few separate parts, and one of those is the Fender Splash Shield (Right, Front). Very often, your INFINITI's fender splash shield can be found inside the wheel well, and creates a barrier in between the fender frame and your tire. Fender splash shields are made-to-fit to fit only in certain locations on your INFINITI: passenger-side front, passenger-side rear, driver-side front, or driver-side rear. These shields are also made for use in specific INFINITI years and models.

Due to their positioning on your vehicle, your Fender Splash Shield (Right, Front) is the outermost layer of defense from incoming debris and contamination. As an example, if a truck drives past your vehicle and its tires send a rock straight toward your wheel well, your trusty Fender Splash Shield (Right, Front) can stop the debris from bouncing into the brakes, headlight or tail light assemblies, or undercarriage. Plus, the Fender Splash Shield (Right, Front) may help protect these parts from outside elements, which could slow damage or corrosion.

Over time, when exposed to road salts, rain, ice, and heat, your INFINITI Fender Splash Shield (Right, Front) may become worn, which compromises the protection it offers to your vehicle's complex systems. Additionally, it may break or detach if you scrape a curb or encounter a pothole while you're driving at a high speed. If it's broken, your Fender Splash Shield (Right, Front) exposes your vehicle to dangerous debris, and it will likely generate a flapping or grinding noise if a broken piece is pushed against the tires.

The good news: installing a replacement for the fender splash shields on your INFINITI is inexpensive and simple to do. You'll need a replacement Fender Splash Shield (Right, Front) that attaches to your INFINITI without any gaps, so it's wise to buy an authentic part from INFINITI Parts. Depending on your specific vehicle, the replacement process can vary a bit. In most cases, you'll need your INFINITI owner's manual, a screwdriver, and some fasteners.

You'll start by letting your car cool down. Next, remove the clips and bolts that hold the fender shield on your vehicle now. If you plan to reuse the old bolts and clips, set them aside for a few minutes (whenever possible, it's best to purchase new ones, in case the existing hardware is worn). To test the fit of your new Fender Splash Shield (Right, Front), set it inside your wheel well, ensuring any rivets and holes match the holes on your fender. Once everything is aligned, screw or clip the Fender Splash Shield (Right, Front) into place and secure it! For help with this process, stop by a local INFINITI retailer or authorized service center.

With the right tools and an authentic Fender Splash Shield (Right, Front) in your corner, you and your INFINITI can be back up to speed with confidence! Buy top-quality INFINITI fender splash shields and additional parts and accessories for your INFINITI Q60 today. Check out the What This Fits tab for additional details.

Fits Q60