When it comes to keeping your INFINITI moving, a functioning Wheel Bearing And Hub (Front) is essential. If it's worn out or damaged, the wheels will have a hard time spinning. Using ball bearings, the Wheel Bearing And Hub (Front) ensures the wheel can spin freely while it stays firmly attached to the axle on your INFINITI through the tire rod and ball joints. As the wheel spins, these ball bearings inside the hub allow one side of the Wheel Bearing And Hub (Front) to spin while the other side stays stationary to keep the wheel attached to the vehicle.

Even though the Wheel Bearing And Hub (Front) allows the wheel to spin freely, the wheel shouldn't be loose or have any give when the tire is rocked back and forth. If you think it's time to replace your Wheel Bearing And Hub (Front) and you are confident in your at-home mechanic skills, start by jacking up your vehicle until the tire has cleared the ground. Make sure your vehicle is on a flat and level surface, and put chocks behind the other wheels to keep the vehicle from rolling away during the repair. If you're uncertain about replacing your Wheel Bearing And Hub (Front), visit your closest INFINITI service center for assistance.

Inspect your Wheel Bearing And Hub (Front) by putting a hand on both sides of the wheel and rocking it back and forth. If the wheel has give but the ball joints connecting the wheel to the axle have a difficult time moving, there may be a problem with the Wheel Bearing And Hub (Front).

Driving on a broken Wheel Bearing And Hub (Front) can cause a few things to happen. First, you might note that the tires sound louder than normal while driving. A broken or worn out Wheel Bearing And Hub (Front) can cause an abnormally loud whirring noise that gets louder as you accelerate. Second, your vehicle may seem to be pulling to one side while you drive. While pulling to one side can be a symptom of other issues, such as poor alignment in the wheels, a damaged Wheel Bearing And Hub (Front) can also be the reason. Last, you may notice uneven wear on your tires' tread. Uneven or rapid tire wear can occur when a bad Wheel Bearing And Hub (Front) causes tire pressure to be unevenly distributed.

Does the Wheel Bearing And Hub (Front) on your INFINITI need to be replaced? Get your replacement Wheel Bearing And Hub (Front) from genuine INFINITI Parts to ensure that your new Wheel Bearing And Hub (Front) fits your INFINITI's specific model and trim.

This Wheel Bearing And Hub (Front) and 402021LA2A is made to fit your INFINITI QX56 2011-2020 or INFINITI QX80 2011-2020. See the What This Fits tab for more information.